BAS Mining Trucks offers the Truck Payload Measuring System on all models. This system allows the driver to see the exact total truck weight and payload. The Trucks Monitoring System and Truck Payload Measuring System can be combined to offer a continuous measurement of production in tonnes per hour. It will then also tell the fleet manager when the trucks are overloaded or under loaded and the loader operators can be advised.
In addition to the payloads, the system can also be equipped with an indicator system on the side and rear of the truck allowing the loader operator to know if the truck is loaded to its full capacity or if an additional bucket can be loaded. This results in higher efficiency and lower cost per tonne.
As a stand-alone option, the system will store all loads. At the end of each shift the loads can be downloaded allowing for a correct production calculation.
Knowing the truck payload not only has an advantage from a production point of view. But it also results in a lower cost per tonne because corrective actions can be taken when truck payloads are too high.
The BAS Mining 10x4 tipper runs 24/7 and maintenance and repair will be caried out on site Vicats’ own workshop. Parts are delivered by the local Volvo truckdealer in Lyon. We wish them many pleasant working hours with their new BAS Mining trucks!...
BAS Mining Trucks recently delivered an 8x4 widespread pusher with single mounted tyres to KB Handel. This is already the third BAS Mining truck that KB takes into operation at the OBA in Amsterdam, The Netherlands. ...
Meet our newest BAS Mining Truck model: the 10x4 widespread tipper with a net payload of 56 tonnes. The tippers are in use at the Grensmaas Project in the south of The Netherlands for the haulage of sand and gravel over a distance of 0.5 to 1 km. ...
